Things didn’t work out as I expected, because I lost my
nerve. Instead of leaving the support pin in the epoxy, I withdrew it. I had
visions of the pin being trapped in the hole. I took the view that it would be
safer to form the epoxy paste with a spatula. While I was about it I filled abrasions
on the shaft. I also filled gaps between the pin and the wooden block into
which it was fixed.
2 comments:
Greetings Bill,
Not to fear the next time: applying heat to the pin with a blow torch would have softened the epoxy enough to pull the pin out.
I know it's been a while, but I'm making my fist yuloh. Where on Earth did you get that pivot pin?
Post a Comment